One Bright Second

The last stars will die out 120 trillion years from now, followed by years of just black holes.

Condensed, that’s like the universe starting with 1 second of stars and then a billion billion billion billion billion billion billion years of just black holes.

Stars are basically the immediate after-effects of the Big Bang. A one-second sizzle of brightness, we live in that one bright second.

3D Printer: Extruder Calibration and Estep adjustment

To calibrate your 3d printer’s extruder

We need to know the printers current e-step value, and a physical steps/mm value (what the printer is actually spitting out). This calibration is especially important if you’re changing the extruder from one that uses gears like the Titan Extruder found on Anycubic printers to a spindle drive.

Determining your current steps/mm value for your 3D printer

Connect PC to USB port on printer.
Download and run “Pronterface”. Once connected, In the Command Window enter M503 (report settings)
Look for a line starting with M92 and at the end you’ll see your current e-step (steps/mm) value

example. echo: M92 X80.00 Y100.00 Z400.00 E405.00

Determining the physical steps/mm value for your 3D printer

Heat the extruder on your printer.
Using calipers and a sharpie, place a mark on your filament at 120mm from the entry hole to your extruder.

In pronterface,  Send: G1 E100 F100
This tells the printer to slowly extrude 100mm of filament

Determining the correct steps/mm value for calibrating your 3D printer’s extruder

Measuring the distance from the extruder to the mark on the filament, then subtracting that value from 120:

  • 120 – [length from extruder to mark] = [actual length extruded]

Next, we need to know how many steps the extruder took to extrude that much filament. We can determine this value by multiplying the steps/mm value by the length we should have extruded, in this case 100 mm:

  • [steps/mm value] x 100 = [steps taken]

Using this, we can obtain the physical, correct steps/mm value by dividing by the length extruded:

  • [steps taken] / [actual length extruded] = [accurate steps/mm value]

Now, all we have to do is set this as the printer’s steps/mm value, and we should be good to go!

Full all3dp article here

Saving the correct e-steps/mm value for your 3D printer

M92 E <step value> (sets the new step value)
M500 (to save)
M501 (use new values)